The Fetrotech tool silver works with pcmtuner because PCMtuner has a bridge at this point. It works on the same software, the difference is in the bridge. One of our customer took both black and silver board and found the difference. if you want your silver fetrotech to work alone. then do a little modification.… Read More »
Fetrotech Tool Silver Feedback from iecutool.com customer: After install, and received licence, reinstall Fetrotech setup again, will work no problem (Windows 7 Ultimate x64) Disable all antivirus and firewall. EDC16C34 – Read/Write OK MD1CS003 – Read/Write OK
Some users had problems reading Mercedes EDC16CP31 ECU with fetrotech tool. Tried all listed pinouts on pcm tuner list, no connection. Says s1&s2 pinout error. Users found a few different pinouts for this ECU and none of them worked. Solution: Please see attached for Mercedes-Benz EDC16CP31 on fetrotech. Use this top pinout pay attention to… Read More »
Q: Fetrotech tool black not possible read Citroen c5 aircross 1.3 puretech Md1cs003 2020year. There is no access to the ECU. Solution: Security change on most MG/MD ECU in 2020 Fetroteh tool cannot read if car sold after july 2020. ecu is locked. After 2020 not all Expensive tools support, in fact BMW/toyota still not… Read More »
Fetrotech tool (Silver) read and write 2018 Peugeot 5008 MD1CS003 ecu successfully. 2018 – Peugeot 5008 1.5 BlueHDi 130HP MD1CS003 – Read/Write and do checksum. Very fast. Amazing.
Hyundai Tucson 2.0 CRDI 2006 EDC16C39 ecu read ok with fetrotech tool very fast. Hyundai Chevrolet EDC16C39 pinout Fetrotech read and write without problem
Question: Renault EDC16C3 fetrotech tool not read with this pinout. maybe another connection need for read bench mode? Solution: EDC16C3 is not supported, its been covered a multitude of times. Check fetrotech coverage before reading a ECU. http://www.pcmtuner.org/pcmtuner-md1-mg1-edc16-ecu-list-with-fetrotech-tool/
Fetrotech Tool EDC16C2 Mercedes pinout:- please also connect CANH + CANL pinouts for fetrotech are already available, this is fix
Windows 10 is recommended for fetrotech tool software installation. If you have Win7 laptop only, try the solution here. User working experience: ‘I would like to share my experience of installation Fetrotech software on Windows 7 x64 unlimited. So, Fetrotech didn’t want to start after installation. I have tried all tricks/recommendations but no result. Helps… Read More »
Fetrotech tool silver tested on edc17cp14 very fast reading, great. I know pcmtuner read and write good on edc17cp14. I do couple edc17cp14 with pcmtuner, but I now tested fetrotech, it’s faster than pcmtuner and auto detect processor type. http://www.pcmtuner.org/pcmtuner-failed-to-read-edc17cp14-on-bench/
