Here comes the problem: Foxflash software is on Low so the power is not connected, it is not working, all buttons are gray. Do you have an idea? Possible solutions: 1. Click on download and it will be fixed. 2. Change the USB cable, power and USB port of PC 3. Change another clean operating… Read More »
Here comes the user report: OBDSTAR X300 Classic G3 Clone Ford Transit 2011 BCM successfully. Need to activate ECU/TCU flasher license to the G3. You can do cloning with DC706 as well. Go to Body Module, quick search Ford BCM SIEMENS 0L01Y (9S12DT256) Choose Bench mode with P004 adapter. Check wiring diagram. Connect BCM module… Read More »
Xhorse Multi Prog read and write Nissan Bosch EDC16C41 ECU on bench successfully. It is a NISSAN W41 bus. ECU: BOSCH EDC16C41 Read bench ok. Write bench ok. Checksum by multi prog. DPF REMOVED. www.iecutool.eu
Foxflash new user feedback: Opel Meriva 1.7DTi DELCO E4 OBD read ID- OK. READ ECU via OBD OK WIRITE ECU via OK CHECKSUM- failed. Foxflash failed to correct checksum via OBD, manually correct checksum with L-suite. www.iecutool.eu
It is a Fiat Ducato year 2011 2.3L 16V with MJD 8F3 ECU. Foxflash reads and writes this ECU via full system successfully. MJD8F IAW MUJET Full system Read ok . Write ok. Checksum by foxflash. FULL SYSTEM DPF + EGR OFF. You can also do it via OBD, but OBD takes too much time.… Read More »
Foxflash new user feedback: Ford Ecoboost MED17. 2 ECU Ecu was brought in by battery short. Read on bench ok Write on bench ok Checksum by foxflash. Another successful rebuild. Ecu tests and verifies. Success. BOSCH MED17.2 [ 1767 ] – Ford [Gasoline] bench pinout To read and write use the following driver: → BENCH… Read More »
Will Alientech KESS3 read/write Scania EMS S8 / EMD1 ec? Is it possible do via OBD or need bench? For example 2018 Scania R450 EU6 Yes, People have done a lot of them without problem. Flash in obd with id only or real reading in harness then writing by harness or by obd. only… Read More »
Foxflash new user feedback: TOYOTA Bosch EDC17CP37 ECU Read bench ok Write bench ok Checksum by foxflash DPF + EGR OFF ok
Foxflash programmer read and write Renault SID304 ecu via BDM successfully. Siemens SID303 / 304 Pinout Solder the dip/sip connectors on the pcb and insert Siemens/Marelli adapter as in photo: To read and write use the following driver: → BDM/ JTAG MODE → BDM MPC → MPC55x/56x Read ok Write ok checksum by foxflash.… Read More »
Problem: Try to update the firmware of Alientech kess3 programmer but failed, software gave error “Tool Update Error” Any solution? Solution: Alientech usb cable isn’t highest quality. It’s advised not to move cables during operations, USB cables are susceptible to problems when they are moved. Remember to always connect your power supply adapter whenever you… Read More »
