Foxflash user new test report: Certainly a simple job, but tested with mobile equipment. Simply to demonstrate how alternative work can be done, which tools are needed and which are good, and which electrical parameters play a role. Bosch EDC17C64 ECU in Bench Mode Read IntFlash 5min 16sec Read EEPROM 0min 3sec Write IntFlash 1min… Read More »
With the latest Alientech KESS3 software update (V2.17), you can now perform VAG Bosch MG1CS004 ECU VR reading and write directly via OBD on these ECUs, making your operations faster and easier. Important note: MD1CS004 ECUs with hardware H80 can only be managed via OBD. These specific ECUs cannot be accessed using the BENCH mode. Check compatibility… Read More »
OBDSTAR DC706 or G3 will do VAG Bosch ME7.5.10 Kline ECU immo off in boot mode. Check instructions here. Quick search ME7.5.10 Kline ECU Select Boot mode with MP001. Check instructions and wiring diagram. Open the ECU module cover and solder the wires according to the soldering diagram. Connect ECU. Read and save ext eeprom.… Read More »
Xhorse Multi Prog read and write GM Bosch EDC16C9 ECU on bench successfully. It is a Opel/Vauxhall Vectra. Read ext eeprom, ext flash and int flash all fine. Write ok as well. Got no issues with EDC16C9. Just tried one. Check wiring, power supply etc. See if diagnostic can talk to ECU on the bench.… Read More »
CG FC200 supports VAG DQ200, VL381, DQ250, DL381 gearbox mileage correction on bench. Here we will show how to correct mileage for DQ200 (0AM) gearbox. Select VAG Temic DQ200Dxx TC1766 gearbox in software. Check wiring diagram and connect gearbox with FC200. Connect CAN-L, CAN-H, 2x12V and GND cables. Identify gearbox. The mileage data is stored… Read More »
Here’s a comparison of the Magic Motorsport Flex, Alientech KESS3, Autotuner, and DFOX ECU tuning tools based on their features, capabilities, and use cases. This breakdown aims to help you understand their strengths and weaknesses for ECU tuning and remapping tasks. 1. Magic Motorsport Flex Overview: Developed by Magic Motorsport, an Italian company, Flex is… Read More »
Finally managed to read and write Volvo Visteon ESU-413 with foxflash programmer via jtag mode. Have tried numerous times with another ecu without luck but that mcu must be completely dead/bricked. So just to let every one know, it’s possible to read/write Volvo ESU-413 with foxflash even tho i’ve seen posts about it’s being impossible.… Read More »
In the fast-evolving world of automotive tuning, choosing the right ECU (Engine Control Unit) tuning tool can make or break your experience—whether you’re a professional tuner or an enthusiast looking to optimize your vehicle’s performance. Two standout contenders in this space are the Alientech KESS3 and the Autotuner. Both tools have earned strong reputations, but… Read More »
OBDSTAR X300 Classic G3 full read and write Fiat Bosch edc15c7 ecu in boot mode successfully. Read and write ok in boot mode. Read ext eeprom and flash ok. Write ext eeprom and flash ok. Bench mode is not working.
OBDSTAR DC706 new user report: Did a 2012 Chevrolet Cruze ecu clone E78. I read both the eeprom and flash files and wrote both files to the new ecu. Using P004 adapter on bench mode. Better read ShadowFlash as well. DC706 offers us the option of writing by boot, but when trying to connect, the team… Read More »
