Category Archives: PCMTuner Pinout
Tips to Read Fiat/Iveco EDC17CP52 ECU with PCMTuner
Fiat Ducato Edc17cp52 ECU works perfectly with pcmtuner. Fiat Iveco EDC17CP52 bench read/write without problem in module 71. Here comes the pcm tuner pinout to edc17cp52 It’s good. A lot of users did it in bench module 71 reading and writing ok without any problem. Requires capacitors on gpt connections. Need GPT1 +10uF or 100uF… Read More »
PCMTuner Read Ford Kuga EDC17C70 via OBD or Bench?
PCMTuner Vauxhall EDC17C59 No Communication Solution
Question: Edc17c59 Vauxhall zafira, following pcmtuner pinout and trying to read on module 53 tc1767 but no communication, am I missing something? Solution: well module 53 is BSL so unless you have opened ECU and connected boot pin then it wont read or write. Use module 71 in bench mode. Feedback: Got it… Read More »
PCMTuner Bosch MEV17.2.1 Pinout
Q: I am looking for the pcmtuner pinout for a mev17.2.1 and I found it but there is a brown thread and I don’t know what it corresponds to. A: lay it down in 29 and lay back in 11 Here is the pcm flash pinout MEV17.2.1 TC1796 the other sent from the pcmtuner… Read More »
PCMTuner Nissan March ME 17.9.55 ECU Pinout
Problem: Can I read Nissan March 2016 1.6 petrol engine ME 17.9.55 ecu with pcmtuner? I tried module 71 but it is failing. Solution: pcmtuner ME17.9.55 ecu pinout use labels not colors. try GPT0 and GPT1 on pins marked yellow (any order may swap later), but please power everything off and restart PCM tuner and… Read More »
Tips to Read VW MED17.1.27 ECU with PCMTuner
Q: Is it possible to read the VW MED17.1.27 control unit ecu with pcmtuner? I made the connection but failed. Solution: Here is the MED17.1.27 pinout to pcmtuner module 71 If failed to read ecu, disconnect EVERYTHING, Repin ECU slowly and carefully making sure all pins are contacting, make sure the breakout cable is pushed… Read More »
PCMTuner Software Blank No Show Instruction Page?
Here comes the problem: My pcmtuner software is no longer showing me any pinout connection diagrams, it’s just showing blank on instructions page after choosing the ecu to work on. I don’t know whats going on with it. Instruction page is just blank. Possible reason: 1. This ECU is not supported so pcmtuner will not… Read More »
PCMTuner Read and Write Iveco EDC17C49 on Bench
PCMTuner flash Iveco edc17c49 read/write OK. Here is the edc17c49 pinout to pcmtuner this is trick for iveco you need capacitor for gpt Make sure capacitor polarity is correct, + to pcm tuner and – to ecu. Put capacitor 10uF only between ECU pin 59 and gpt01 brown wire. There are 2 possibilities for canbus… Read More »
How to Read Ford SID211 ECU with PCMTuner?
Question: Do you have some tips or things to know about SID211 Read and write using pcmtuner? Answer: Module 7 for writing over OBD but must unlock ecu in BSL with 53 first, bsl unlock requires ecu to be opened. BSL with Module 53 for Ford transit. Read password and save before putting into… Read More »