Audi A8 W12 Master and Slave Motor Ecu ME7.1.1 Full Ok, read and write by foxflash programmer.
ME7 1.1 and ME5 are such ECUs!
Checksum is red, but it works, the engine started. No Problem.
BOSCH ME7.1.1 [ C167 ] – Volkswagen, Audi, Seat, Skoda [ Gasoline ]
Need to connect 1 resistance of 10 KΩ
To read and write use the following driver:
→ TOOLS BOOT MODE
→ SIEMENS-INFINEON C167
→ Bosch – Flash 29F800
If it is HW2, follow this pinout
BOSCH ME7.1.1 Vers.2 [ C167 ]
To read and write use the following driver:
→ TOOLS BOOT MODE
→ SIEMENS-INFINEON C167
→ Bosch – Flash 29F400
Attention:If the ECU doesn’t enter boot mode, proceed as follows:
→ Switch off the ECU and remove the grey wire.
→ Connect directly to ground the boot pin with a needle.
→ Switch on the ECU.
→ Remove the ground.
→ Launch the driver and click the read / write buttons.