Formula Flash is a professional ECU tuning tool that supports: ECU/TCU data reading and writing for common models Immo OFF Power upgrades DTC OFF VIN modification These are the most frequently asked questions and key functions of the FormulaFlash. What are the advantages of FormulaFlash? Combining 10 years of industry expertise with innovative… Read More »
Problem: Had a problem with PADFlash programmer software. Cannot select drivers, all buttons are gray. Possible reasons and solutions: 1. Operating system. Better load software on a clean Win7 64bit system. 2. Administrator privileges. Grant the computer administrator highest privileges. If the problem still exists, contact www.iecutool.eu customer service to address the problem via… Read More »
Problem: Failed to start PADFlash programmer software after activation. It reported an error “Download Limit Exceeded”. How to fix it? Solution: He has downloaded too many times and exceeded the limit. It will be restored automatically after 24 hours. Then try again after 24 hours. www.iecutool.eu
Foxflash programmer’s new feedback: It is a dcm3.7 vw ecu, the customer had modifications done by a friend and he thought it was lighter. After opening the ecu I found that Inductor to jump on the lines CAN H / CAN L. Reading diagnostic suitcase with godiag. Foxflash read ID via OBD with godiag ECU… Read More »
The OBDStar DC706 ecu tuning tool recently added a new feature that has sparked excitement among automotive enthusiasts and tuners: an ECU Unlock tab for the Chrysler GPEC2A ECM. This update suggests a streamlined way to unlock ECUs for tuning, potentially eliminating the need for manual hex editing or file transfers. But does it actually… Read More »
Problem: Had a problem with PADFlash software. Connect the USB dongle, run software and try to activate, no response, no activation message came out. Solution: Disable anti-virus program. This laptop does not have a USB 2.0 port. There is a USB Hub in the PADFlash package. Conncet PADFlash dongle and USB cable to the USB… Read More »
This article explores the key differences between the Hextag II and Xhorse Multi-Prog, providing insights to help automotive technicians, and programmers choose the right tool for their requirements. Overview of Hextag II The Hextag II is a professional-grade automotive programming tool known for its versatility and advanced capabilities. It is widely used for ECU cloning,… Read More »
The Launch X-prog3 is on the same level as the autel xp400 pro where it is more limited? in which the Autel is more powerful? Here is the clue. Launch X-Prog3 (GIII) A professional immobilizer and key programmer, often used with Launch X431 diagnostic tablets (e.g., X431 V+, Pro5, PAD VII). Specializes in ECU/TCU cloning,… Read More »
It is a Toyota Aygo Bosch ECU ME7.9.52. First try full system read with foxflash, but it was not possible with this ECU, got an error that reading was not possible. So try boot mode. ME7.9.52 boot mode Decat. Read and Write ok. Checksum all by foxflash. Also did a Citroen C1 2010 ME7.9.52 ECU… Read More »
Possible to read and write Audi Siemens PPD1.xx ECU with PADFlash programmer? Yes, PADFlash does it well. For example: Audi A4 2.0 TDI PD | 2008 ECU: Siemens SIMOS PPD1.3 Operation mode: BDM Jtag Read and backup ext Flash and eeprom ok. Write eeprom and flash ok. Images attached:
