Problem: Double-clicked Foxflash software icon on the desktop, but it is not working. No response. Any solution? Solution: Your computer system does not have administrator privileges. Make sure super administrator privileges are enabled (Google search how to enable super administrator privileges.) Or change another operating system (Win10 64bit is better) www.iecutool.com
If fails to read VAG DL501 gearbox TCU with foxflash, check if bench box is connected. It cannot read if not connecting bench box. Foxflash reads/writes DL501 TCU no problem, check http://www.pcmtuner.org/foxflash-read-and-write-porsche-dl501-gen2-gearbox/ PCMTuner also read/write DL501 gearbox without issue. For example: Audi A6 TCU Dl501 read and write with PCM tuner success
Problem: Foxflash read Opel Astra Delco E98 ok, but failed to write via OBD, error DAT1. Any solution? Solution: Raise voltage. If still fails, do it via Full system. Don’t connect bench box if doing full system. Tested by many without problem on bench. For example: http://www.pcmtuner.org/foxflash-read-and-write-open-insignia-delco-e98/
Foxflash user feedback: Foxflash Read and Write Marelli mjd 8ds in jtag mode successfully Read by fox ok Write by Fox ok Checksum by fox ok You can also do full system no need to open the ecu. if I did a full read but only needed flash while writing. MJD 8DS jtag pinout to… Read More »
Foxflash user feedback: Citroën jumper 3 2021 Stage 1 Dcm7.1a Boot mode Read/write ok Checksum by foxflash perfectly Only one difficulty find & reach the pin boot under the processor but with good eye its ok. Check DCM7.1A/B boot mode pinout here http://www.pcmtuner.org/foxflash-read-and-write-citroen-jumper-dcm7-1b/
Foxflash user feedback: Hyundai i30 2009 Ecu Kefico/bosch m7.9.8 Read ok in boot Write ok in boot Checksum by foxflash Immo off Pinout is in the document.
Foxflash user feedback: Porsche DL501 Gen2 gearbox TCU Read bench ok Write bench ok Checksum by fox Foxflash pinout to Porsche DL501 Gen2 TCU
Where to find foxflash OTB adapter pinouts? Open the foxflash manager install folder there is a folder called ‘Document’. The OTB pinout can be found in the document folder. PDF format in Help folder or check online version via browser. For example, search desired ECU in ‘help’ folder, i.e EDC16U1 You will see bench… Read More »
Iecutool.com here shows an example of using the Foxflash and OTB adapter to read a Mercedes Crd3 ecu using obd driver. This is the CRD3.20 ECU What’s needed: Foxflash OTB Adapter Power supply OBD Cable Mercedes Benz CRD3.20 pinout Identify needed OTB connection Prepare some cable connections Connect to foxflash OTB adapter Connect to ECU… Read More »
Foxflash user feedback: e2x0 mercedes 2017 ECU: Mrd1co001 bench all ok read ok write ok checksum by foxflash
