Foxflash new feedback: Toyota yaris 2010 1.4tdi ECU EDC17CP07 Foxflash read bench ok write bench ok Checksum by foxflash Wild setup, too lazy to rip ecu out, egr dpf off Foxflash Toyota Bosch EDC17CP07 pinout To read and write use the following driver: → BENCH TRICORE → TOYOTA → TC1766 – TOYOTA → EDC17 CP07 www.iecutool.com
How to read Peugeot 208 1.2 ecu valeo v56.12 calculator with Foxflash? Foxflash has no protocol for this ECU. It cannot read V56.12. Need Alientech KESS3 or Autotuner. KESS3 will read and write Valeo V56.12 in boot mode. Supported models: Citroen C3 1.2 PureTech 82 Petrol 61 Kw C1 1.0 Vti 72 Petrol 53… Read More »
Foxflash reads Renault EDC17C42 ECU ok, but failed to write. It is write protected, error “OTP sector not writable”， what else can I do? Bad modified file, you are changing OTP section. People have done EDC17C42 OBD and Bench working all ok. Not protected. Your file is bad. Change your tunner supply!!! Bad Solution. Bad… Read More »
Foxflash new feedback: Sid307 sak tc1767 in Mercedes Benz A180 1.5TDCI @ STAGE 1 Read Password on bench. Read/Write/checksum correction in boot mode. No pass via obd, only in boot connection. MB SID307 boot pinout to foxflash Connect with the multifunction cable the following pinout and the boot shown below. Use the driver: → TOOLS BOOT… Read More »
Foxflash new feedback: sometimes it doesn’t even work on bench the Crd3 ecu’s are sensitive so to save time the boot is there for security. Mercedes cla shooting break Cdi 200 Ecu Crd3E1 Boot mode ok Read/write ok Checksum by foxflash
Seat EDC15p+ read, edit and write ok with foxflash. Checksum correction manually. Because foxflash does not take the correction into account. Foxflash pinout to edc15p ecu BOSCH EDC15P / EDC15V – Volkswagen, Audi, Seat, Skoda [Diesel]
Foxflash new feedback: VW GOLF VI SIMOS PCR2.1 OBD OK READ OK EGR OFF OK WRITE OK Checksum by foxflash. I have disconnected and connected the battery to make flash unlock. i make obd perfectly. Car starts. www.iecutool.com
Problem: I tried to read Mercedes CRD3Plus.A0 ecu with foxflash. had 2 different tuning files checksum wrong any advice? Solution: Write only flash not all. Feedback: I’ve worked it out I’ve read full file and had that modded and therefore it won’t write it either way correctly so I’ve reread just the flash file… Read More »
Foxflash user feedback: JCB Dcu17cv51 is not in foxflash list. Boot mode Tc1724 pinout from other tool. but sitll can read and write, stable amazing foxflash. BOSCH DCU17CV51 IROM TC1724 JCB Boot Pinout
Problem: Anyone successfully write file on Mercedes MSM2.0? After read flash and eeprom i restart software and foxflash device but was not successful in writing. Solution: Keep ON and write. Don’t wait tool ask you to make ON. Use this instruction all time you read and write without bench box. If you use bench box… Read More »
