Foxflash programmer can read and write Ford/Fiat/Peugeot/Citroen DCU102 Visteon ecu in boot mode. You must copy flash in ST10 boot mode and eeprom.
Kit to use:
– Multifunction cable
– 2 resistance of 1000 Ω
Connect multifunction cable and the resistances as shown
To read and write use the following driver:
→ TOOLS BOOT MODE
→ ST ST10Fxxx
→ ST10F273 / ST10F275 / ST10F276 *K
or
→ ST10F273 / ST10F275 / ST10F276 *CAN
Alternatively, read via RX TX:
Kit to use:
– – Multifunction cable
– – 2 resistance of 1000 Ω
— Transistor PNP 2N3906
Connect multifunction cable and the resitances as shown.
To read and write use the following driver:
→ TOOLS BOOT MODE
→ ST ST10Fxxx
→ ST10F273 / ST10F275 / ST10F276 *RxTx