How to read and write psa edc15c2 ECU with Foxflash?
Remove eeprom or boot mode.
By boot its simple.
Pin 24 on the ground with resistor of 5k
Power off
Pin 24 on the ground
Power on
No Pin 24 on the ground.
BOSCH EDC15 C2 [ C167 ] – Peugeot, Citroen [Diesel]
Attention:
If the ECU doesn’t enter boot mode, proceed as follows:
→ Switch off the ECU and remove the grey wire.
→ Connect directly to ground the boot pin with a needle.
→ Switch on the ECU.
→ Remove the ground.
→ Launch the driver and click the read / write buttons.