Tag Archives: foxflash pinout

Question: I cannot see EDC17C74 in foxflash driver list, only EDC17CP74, the question is whether it can be used to write EDC17CP74? Answer: EDC17C74 driver is there. To read and write use the following driver: → BENCH TRICORE → VOLKSWAGEN / AUDI / SEAT / SKODA → TC1793 – VAG → EDC17 C74 Foxflash pinout… Read More »

Possible to read and write Renault Simens SIM32 with foxflash? by OBD, bench or jtag? Yes, foxflash will read and write SIM32 (if it is not encrypted), both OBD and jtag. No bench.     OBD mode: tested working. for example, E85 solution on Renault Twingo 1.2: Ecu Siemens Sim 32 Read & Write ok… Read More »

Problem: I was trying to read JCB Dcu17cv51 ECU with foxflash. it is in the manuals section, but under jcb tc1724 is not listed. Anyone had to deal with this before? Solution: You can find JCB Dcu17cv51 in boot mode.   Connect with the multifunction cable the following pinout and the boot shown below. Bosch… Read More »

Will foxflash read and write PSA edc16c3 ecu? on bench or by BDM mode?     Bench mode: BOSCH EDC16 C3 [ MPC556 ] – Citroen, Peugeot [Diesel] Connect the multifunction cable as follows, use the Bench Box: Set the resistance of 1000 ohms that starts from the bench to the brown wire and after… Read More »

Problem: I tried to read a Merelli IAW 59F control unit of a fiat punto 1.28v but foxflash software gives an error. does id identification but does not read file. I tried with another one from an Opel corsa c1.2 and it gives the same error. Why the reading fail? Solution: Double-check wiring. Don’t connect… Read More »

Question: If foxflash read and write North American truck ECU-Cummins CM2350? Answer: Yes, it will read and write via Jtag mode.   Continental CM2350 – Cummins pinout to foxflash Kit to use: – Multifunction cable – Rainbow flat cable Connect multifunction cable as follows:   Solder the rainbow flat cable and make a link: To… Read More »

BMW MSD87 read and write data with foxflash successfully. Foxflash pinout to BMW MSD87   SIEMENS MSD87 [ TC1796 INT-EXT.F.] – BMW Step 1: Password Search To find the password, connect via OBD to the car. Use the driver: → TOOLS BOOT MODE → INFINEON TRICORE Tool Password → OBD PASSWORD MSD80/81/85/87 BMW → Click… Read More »

Fiat 500 MARELLI  IAW 9GF read/write with foxflash successfully on bench in car. MARELLI 9GF – Fiat, Alfa Romeo, Lancia [Gasoline] bench pinout to foxflash   read, write ok, checksum by tool.

Q: Who were able to read/write VAG DSG DQ200 MQB Gen2 gearbox with Foxflash?  What is the correct pinout?   A: Yes. it works. Golf 7 MQB Gen2 full read OK with fox flash. DSG DQ200 MQB Gen2 Pinout to Foxflash TEMIC DQ200 (0AM, 0CW) GENERATION 2 DSG DQ200 MQB Gen2 Since 2019 Foxflash pinout… Read More »