Problem: I need the Fetrotech tool pinout for EDC16U31, I tried to use the pinout from Tuner box but the error is S1 and s2 pinout error. Solution: Use the first wiring diagram. Fetrotech read ok. Try swapping GPT’s, others have reported connecting the CANL and CANH also can make it read.
Read and write EDC17C60 PSA with fetrotech tool black successfully, DFP+EGR+ TPROT OFF. tprot off manually same as with pcmtuner. reading/writing with fetrotech, DPF+EGR off by DAVINCI 1. O. 28, TPROT off with WINE. checksum with wimols, fetrotech also does it
The Fetrotech tool silver works with pcmtuner because PCMtuner has a bridge at this point. It works on the same software, the difference is in the bridge. One of our customer took both black and silver board and found the difference. if you want your silver fetrotech to work alone. then do a little modification.… Read More »
Fetrotech Tool Silver Feedback from iecutool.com customer: After install, and received licence, reinstall Fetrotech setup again, will work no problem (Windows 7 Ultimate x64) Disable all antivirus and firewall. EDC16C34 – Read/Write OK MD1CS003 – Read/Write OK
Some users had problems reading Mercedes EDC16CP31 ECU with fetrotech tool. Tried all listed pinouts on pcm tuner list, no connection. Says s1&s2 pinout error. Users found a few different pinouts for this ECU and none of them worked. Solution: Please see attached for Mercedes-Benz EDC16CP31 on fetrotech. Use this top pinout pay attention to… Read More »
Q: Fetrotech tool black not possible read Citroen c5 aircross 1.3 puretech Md1cs003 2020year. There is no access to the ECU. Solution: Security change on most MG/MD ECU in 2020 Fetroteh tool cannot read if car sold after july 2020. ecu is locked. After 2020 not all Expensive tools support, in fact BMW/toyota still not… Read More »
Fetrotech tool (Silver) read and write 2018 Peugeot 5008 MD1CS003 ecu successfully. 2018 – Peugeot 5008 1.5 BlueHDi 130HP MD1CS003 – Read/Write and do checksum. Very fast. Amazing.
Hyundai Tucson 2.0 CRDI 2006 EDC16C39 ecu read ok with fetrotech tool very fast. Hyundai Chevrolet EDC16C39 pinout Fetrotech read and write without problem
Question: Renault EDC16C3 fetrotech tool not read with this pinout. maybe another connection need for read bench mode? Solution: EDC16C3 is not supported, its been covered a multitude of times. Check fetrotech coverage before reading a ECU. http://www.pcmtuner.org/pcmtuner-md1-mg1-edc16-ecu-list-with-fetrotech-tool/
