Will Alientech KESS3 read/write Scania EMS S8 / EMD1 ec? Is it possible do via OBD or need bench? For example 2018 Scania R450 EU6 Yes, People have done a lot of them without problem. Flash in obd with id only or real reading in harness then writing by harness or by obd. only… Read More »
Problem: Try to update the firmware of Alientech kess3 programmer but failed, software gave error “Tool Update Error” Any solution? Solution: Alientech usb cable isn’t highest quality. It’s advised not to move cables during operations, USB cables are susceptible to problems when they are moved. Remember to always connect your power supply adapter whenever you… Read More »
AUDI Q2 transmission cloning by Alientech KESS3 programmer successfully. Audi Q2 8U1 2016 TCU Temic DQ200G2 Protocol: 1625 Bench mode cloning ok. Need to have car/LCV bench mode activated.
Alientech KESS3 free update DTC feature on June 27th, 2024. Through the EOBD connection of KESS3, Alientech Suite retrieves the list of (SAE – Society Automotive Engineers) error codes recorded during vehicle operation, helping mechanics and mechatronics easily identify potential faults and damages. WHAT ARE THE KEY POINTS OF THE NEW DTC FEATURE? DETECTION… Read More »
Car model: Kia Rio 1.1 2013 CRDi 2K14 ECU: Delphi DCM3.7 Using Alientech KESS3 protocol 1101 Need a full read eeprom and micro. Read and write on boot mode successfully. DCM3.7/AP has 2 types of processors inside. One you can do over OBD but the other not. Some delphi dcm3.7ap need to read by jtag.
Alientech KESS3 new user feedback: Tt’s a 4hk1 24v Isuzu ECU. Need to immo off, stolen crashed recovered. KESS3 will read via OBD. But need a full boot read for immo. Using the protocol 430. Finally had a go at booting a Transton, everything is wired correctly, getting the ID and read the ecu successfully.… Read More »
Alientech KESS3 new user report: New Holland Model: T4 2021 Version T4.65 3.4L ECU Bosch MD1CS069 Protocol 1678 Read on bench Write on bench Checksum by kess3. Need truck/agricultural machinery license activated. www.iecutool.eu
To read Fiat Magneti Marelli IAW 9DF ECU, you have 3 options: 1.Flex in boot mode You have to open the ecu or make a hole in the center of the inscription “Magneti” Marelli” and connect the starter through the hole With Flex you can have a vr file but it doesn’t can’t write in… Read More »
Alientech KESS3 read and write Isuzu NPR85 ECU successfully. Fault code P1455 Mode: N-series, NPR85 Engine code: 4HK1-TCN ECU: 4JJ1-1 Protocol: 430 Read ok write ok DPF OFF, EGR Off Checksum by kess3. www.iecutool.eu
Alientech KESS3 read and write Mercedes Benz Sprinter 303CDI W906 ECU successfully. Model: Sprinter 303CDI W906 ECU: DELPHI CRD2 Mode: OBD Remapping via OBD with Alientech Kess3
