Problem:
I failed to read Fiat Ducato Marelli MJD 8F IAW ecu with the foxflash programmer on bench. It reads ID but failed to read data (error boot1). Any advice?
Solution:
Foxflash will read and write Marelli MJD8F full system. It will read the whole backup.
DON’T CONNECT BENCH BOX WHEN READ THIS ECU.
![Foxflash Fiat Mjd8f 1](http://www.pcmtuner.org/wp-content/uploads/2024/01/foxflash-fiat-mjd8f-1.jpg)
You can also read and write with foxflash in jtag mode.
MARELLI MJD 8F, 8S, 8DS – FIAT, Suzuki [Diesel]
Connect the multifunction cable as follows:
Solder the rainbow flat cable on the pcb:
To read and write use the following driver:
Related reading:
http://www.pcmtuner.org/kt200-failed-to-read-fiat-marelli-6f3-solution/