Question: Can pcmtuner read this Delphi CRD 11 ECU from Mercedes. or other tools? PCMTuner will not read crd11. Ktag will read and write via BDM. ECU – Ktag 3-6 2-1 4-5 6-10 8-7 10-8 And make 2 Bridge. Ktag Protokoll 119 Ecu Delphi DCM3.2 CRD.11 Foxflash/KT200 will read it via OBD or Jtag. Foxflah… Read More »
Q: I think to buy pcmtuner and i don’t now better pcm tuner or ktag? A: They are different tools – pcm works mostly via obd, ktag only bench or bdm. Pcmtuner does boot also and bench and obd, ktag is just boot / bdm. Get both .and a full jtag kit for… Read More »
If failed to read Hyundai SIM2k-47 ECU with PCMTuner via module 40, you can work on bench with obd breakout cable. Bench pinout of module 40 for ecu sim2k-47 Hyundai On bench worked fine. You need 120 ohm between CAN H and CAN L it should read. Connect GND on Pin 9. Connect this… Read More »
Which tool to read this computer BMW MSV70 DME? Foxflash: Yes, via BDM Jtag Connect multifunction cable as follows: Solder the dip/sip connectors on the pcb and do a link: Insert Siemens/Marelli adapter as in photo: To read and write use the following driver: → BDM/ JTAG MODE → BDM MPC → MPC55x/56x Ktag/Kess… Read More »
Problem: I tried to read CONTINENTAL EMS 3132 Renault with pcmtuner module 38 via OBD, but shows an identification failure. Any idea? Solution: Some succeeded reading Renault EMS 3132 with pcm tuner. But between any identification you must disconnect pcmtuner. Disconnect from OBD port and switch of ignition, restart pcmtuner flash, and plug in obd… Read More »
