Tag Archives: pcmtuner pinout
Fiat Fiesta EMS 2205 Pinout to PCMTuner
PCMTuner Unlock Audi SIMOS 8.6 in BSL Mode
SIMOS 8.6 requires unlocking in BSL mode by the appropriate module. BSL is usually boot mode for unlock. Same as PCR2.1. Example: Audi A7 2012 2.8 fsi simos 8.6 unlock, after read/write simos8.6 with pcmtuner successfully. all resistor 1 kom How to work with blocks that require unlocking (PCR2.1, SIMOS8.6): 1) Check the current lock… Read More »
PCMTuner Read Ford Kuga EDC17C70 via OBD or Bench?
PCMTuner Read and Write Honda EDC17C58 on Bench
PCMTuner Vauxhall EDC17C59 No Communication Solution
Question: Edc17c59 Vauxhall zafira, following pcmtuner pinout and trying to read on module 53 tc1767 but no communication, am I missing something? Solution: well module 53 is BSL so unless you have opened ECU and connected boot pin then it wont read or write. Use module 71 in bench mode. Feedback: Got it… Read More »
PCMTuner Bosch MEV17.2.1 Pinout
Q: I am looking for the pcmtuner pinout for a mev17.2.1 and I found it but there is a brown thread and I don’t know what it corresponds to. A: lay it down in 29 and lay back in 11 Here is the pcm flash pinout MEV17.2.1 TC1796 the other sent from the pcmtuner… Read More »
PCMTuner Nissan March ME 17.9.55 ECU Pinout
Problem: Can I read Nissan March 2016 1.6 petrol engine ME 17.9.55 ecu with pcmtuner? I tried module 71 but it is failing. Solution: pcmtuner ME17.9.55 ecu pinout use labels not colors. try GPT0 and GPT1 on pins marked yellow (any order may swap later), but please power everything off and restart PCM tuner and… Read More »
Tips to Read VW MED17.1.27 ECU with PCMTuner
Q: Is it possible to read the VW MED17.1.27 control unit ecu with pcmtuner? I made the connection but failed. Solution: Here is the MED17.1.27 pinout to pcmtuner module 71 If failed to read ecu, disconnect EVERYTHING, Repin ECU slowly and carefully making sure all pins are contacting, make sure the breakout cable is pushed… Read More »
PCMTuner Software Blank No Show Instruction Page?
Here comes the problem: My pcmtuner software is no longer showing me any pinout connection diagrams, it’s just showing blank on instructions page after choosing the ecu to work on. I don’t know whats going on with it. Instruction page is just blank. Possible reason: 1. This ECU is not supported so pcmtuner will not… Read More »