In this article, we will explore the process of cloning a Smart 450 Body Control Module (BCM) using the Xhorse Multi Prog tool. The goal is to read and transfer data from the original BCM to a replacement unit, ensuring seamless functionality. Step 1: Preparing the BCM The first step involves connecting the Multi prog… Read More »
Possible to read Mercedes Benz ME9.7 ECU with Xhorse Multi Prog? Need to clone the ECU. Multi prog will read and write Benz ME9.7 ECU via OBD mode. Multiprog reads only maps in obd mode, no immo or full read, so it cannot be used to clone this ECU. Use other programmers if you want… Read More »
This article explores the key differences between the Hextag II and Xhorse Multi-Prog, providing insights to help automotive technicians, and programmers choose the right tool for their requirements. Overview of Hextag II The Hextag II is a professional-grade automotive programming tool known for its versatility and advanced capabilities. It is widely used for ECU cloning,… Read More »
Xhorse Multi Prog read and write GM Bosch EDC16C9 ECU on bench successfully. It is a Opel/Vauxhall Vectra. Read ext eeprom, ext flash and int flash all fine. Write ok as well. Got no issues with EDC16C9. Just tried one. Check wiring, power supply etc. See if diagnostic can talk to ECU on the bench.… Read More »
Question: Xhorse multi prog failed to read the Renault Continental ECU SID309. The error is: pflash unprotection failed – connection failed. This ECU is currently not supported by multiprog. sid307, sid309 and sid310 have Tprot password active; if you don’t find before password through obd then you can’t have access to boot. What tools… Read More »
Today we will compare Xhorse multi prog with CG100 Prog III related to airbags. Let’s compare the difference between these two programmers. Connect both of them to PC. CG100 can also automatically repair airbags when you are connected to it. It can repair 90% of airbags. Hhe will write a clear dump. Multi prog… Read More »
Question: How to I combine xhorse multi prog with the Xhorse App and key tool plus? Run Multi-Prog software, go to Update Online tab- Combine device Software will bring a QR code. Scan the QR code with Xhorse App for device binding. Combine multi prog and keytool plus into your xhorse account via… Read More »
Xhorse Multi Prog read and write BMW MSD81.2 on bench mode just fine. Online CKS calculated. Tool extract ISN fine. (Autel also extracts the ISN by OBD, but takes more than 30 minutes). old ecu is dead. I extract ISN from CAS. It worked for me very well. MSD81 full flash and eeprom read and… Read More »
Xhorse Multi Prog read and write Nissan Bosch EDC16C41 ECU on bench successfully. It is a NISSAN W41 bus. ECU: BOSCH EDC16C41 Read bench ok. Write bench ok. Checksum by multi prog. DPF REMOVED. www.iecutool.eu
Xhorse Multi Prog programmer read and write GM Delco E92 ECM on bench successfully. Model: GMC Yukon ECU: Delco E92 Mode: Bench Multiprog will show you wiring diagram. Read INT flash 8bit on bench successfully. Image attached. Multi-prog also read it in boot mode. Boot may ask for pin code. www.iecutool.eu
