You cannot clone all VAG MED17.5.5 ECU on bench. If VW/Audi ECU is updated you will not get password via bench pinout. If no password you might even be required to solder some resistors. If updated no deal via pinout. For example: Vw tiquan med17.5.5 in boot foxflash tool works ok. How to read… Read More »
Foxflash user feedback: Sid806 Citroen c2 1.4 hdi Read/write ok and checksum ok by foxflash. SID806 full system bench pinout to foxflash
Foxflash user feedback: Citroën Jumper Siemens Continental SID208 PSA Password by bench Reading by Boot DPF OFF Writing by Boot All and Checksum by foxFlash Foxflash SID208 Pinout Read also: Foxflash Read and Write Peugeot Boxer SID208 in Boot
Foxflash new test report: I repaired an ECU simtec 81.1 Opel. and made a clone without any problems, without knowing the PIN code from the old ECU. I did it in FULL system mode read. It took me just seconds. I work very calmly with foxflash. SIEMENS SIMTEC81.1 – Opel [Gasoline] pinout to foxflash www.iecutool.com
Problem: When writing alfa Romeo 2017 edc17c69 ecu with foxflash i got an error unlock password… how can I solve it? Solution: Must find password. read it in boot, in bench mode it doesn’t read passwords. Boot mode, find password and then write as normal. BOSCH EDC17C69 [ TC1793 INT.F.] – FCA Boot… Read More »
Foxflash new test report: 2016 fiat abarth 1.4T ME7.3.0 TC1724 is done by foxflash. Read Bench: OK Password found: OK Write bench: OK 2016 model you should bench with no problem.
Foxflash new test report: Continental MSD81.2 DTC Off, Lambda Off, via OBD on Bench Read ok Write OK Checksum by foxflash. ECU removed from the car with pinout like the OBD connection powered from an external source, without the bench box…….some people say that this connection is for the bench, others say that as long as… Read More »
Foxflash new test report: Simos 8.10 boot read and write all fine with foxflash tool. Do not get a heart attack while flashing the ecu takes Power down and up. SIEMENS SIMOS 8.10 [ TC1796 INT.F.] – Audi Read and write ECU Connect with the multifunction cable the following pinout and the boot shown below. Use… Read More »
Foxflash new test report: Dcm 6.2A Peugeot expert adblue off -foxflash read obd ok -Remise reset zero diagbox before writing – foxflash OBD write ok, less than 5 minutes -Checksum by foxflash ok -14v battery charger www.iecutool.com
Problem: After update, foxflash asks to register device again. After input device ID and email, it says ‘User successfully created’. How to fix it? Solution: Close this interface. Run Foxflash manager and register with device S/N again.
