Question: Will Foxflah Unlock and read a L5P GM ECM? Does Foxflash have the unlock service as hptuner*? *HP Tuners offers TCM/ECM/PCM unlock service for tuning support in the latest version of VCM Suite. Yes, foxflash has the unlock service as hptuner. When you need unlock some ECU then work with… Read More »
Problem: FoxFlash Tool can’t connect to EDC16C1 ecu, pinout according to instructions on fox software, I tried on 3 different ones with no result. Some solutions? Solution: Different HW version. Pinout on FoxFlash could work for other c1 versions but not for this one. Solution: 1.Check connection and power supply Pinout (K-Line): *Watch white cable because… Read More »
Car model: BMW 525D ECU type: EDC15C4 Symptoms: After running out of battery, the car does not start. Error code: 02 EWS key code variable incorrect Attempt: tried to do synchronization to reactivate it, but unfortunately all attempts failed Final result: had to cancel the protection code immo off by reading the flash with foxflash… Read More »
Problem: I got the foxflash software installed, but when i run foxflash manager, it gave me the error “Object Reference Not Set to An Instance of an Object”. Same error when i change Win7 and Win10 laptops. Any advice? Solution: Your system is missing net framework and runtime. Download net framework on www.iecutool.com “Download” area.… Read More »
Foxflash will read and write Renault Getrag DC4 transmission TCU on bench. You don’t need to open your Getrag DC4. It will read and write flash and make full backup. Getrag DC4 can be found in following Models: Renault TCU Captur Getrag DC4 GENERAZIONE 1 BENCH Renault TCU Clio Getrag DC4 GENERAZIONE 1 BENCH… Read More »
Problem: I have downloaded foxflash software but it cannot get it started. Software not open and gives 2 errors. Error 1: Fetech data: invalid JSON primitive. Error 2: There is an error in XML document. Solution: Network issue. Change a stable network connection. It should be fine. FYI: If you get blue screen… Read More »
Foxflash programmer read and write vw passat 2.0tdi 150cv 2017 edc17c74 ecu on bench successfully. Read eeprom/flash ok. Write flash ok. Stage1. Checksum manually. foxflash pinout to EDC17C74 To read and write use the following driver -Bench tricore -Volkswagen/Audi/Seat/Skoda -TC1793-VAG -EDC17 C74 www.iecutool.com
Here comes the unbiased review of foxflash ecu programmer on June 1st, 2023. Credit to sazimam. “Because the FoxFlash is working very good for me. I decided to make this review of facts and tested procedures. It works only in ONLINE mode. You won’t run the software without it. It works only with the… Read More »
Problem: Mercedes CDR2 foxflash reading performed OBD. Writing presents an error and presents a message to contact support. what is the solution? Solution 1: CRD2.10 etc is problematic with OBD, you can do JTAG. DELPHI CRD2.10 Solenoid – MPC5566 pinout to foxflash Connect the multifunction cable as follows: Solder 3 links on the pcb Solder… Read More »
Question: I want to read and write a BMS module from Smart 451 EV. Is it possible with foxflash? Answer: Foxflash programmer will read and write Smart EV BMS T1 module on bench. BOSCH BMS T1 [ 1797 ] – SMART EV [ BMS ] Connect the multifunction cable as follows, use the Bench Box:… Read More »
