Possible to read and write Renault Simens SIM32 with foxflash? by OBD, bench or jtag? Yes, foxflash will read and write SIM32 (if it is not encrypted), both OBD and jtag. No bench. OBD mode: tested working. for example, E85 solution on Renault Twingo 1.2: Ecu Siemens Sim 32 Read & Write ok… Read More »
Problem: I failed to download foxflash software. Error ” unhandled exception in the application. If you click Continue. The application ignores this error and attempts to continue. If you click Exit. the application will close immediately. could not read block-no datal.” Server is down? Solution: Your operating system is missing patch and .net framework. Download… Read More »
If your foxflash or new KT200 software crashes when read and write ECU, restart software still same thing happens, you have to enable Administrator elevated Privileges Windows 10 How to Enable Elevated Privileges in Windows 10? Press win+R to run Command, input: gpedit.msc Go to Local Computer Policy->Windows settings->Security Settings->Local Policies In the… Read More »
Problem: I was trying to read JCB Dcu17cv51 ECU with foxflash. it is in the manuals section, but under jcb tc1724 is not listed. Anyone had to deal with this before? Solution: You can find JCB Dcu17cv51 in boot mode. Connect with the multifunction cable the following pinout and the boot shown below. Bosch… Read More »
Will foxflash read and write PSA edc16c3 ecu? on bench or by BDM mode? Bench mode: BOSCH EDC16 C3 [ MPC556 ] – Citroen, Peugeot [Diesel] Connect the multifunction cable as follows, use the Bench Box: Set the resistance of 1000 ohms that starts from the bench to the brown wire and after… Read More »
Question: Possible to read and write JCB DCM7.24 engine ECU with foxflash? cannot find protocol and wiring diagram. Solution: The ecu can be done via OBD. Check vehicle list. Foxflash will read and write JCB 409/TM180 Delphi DCM 7.24 via OBD.
Problem: I tried to read a Merelli IAW 59F control unit of a fiat punto 1.28v but foxflash software gives an error. does id identification but does not read file. I tried with another one from an Opel corsa c1.2 and it gives the same error. Why the reading fail? Solution: Double-check wiring. Don’t connect… Read More »
Question: If foxflash read and write North American truck ECU-Cummins CM2350? Answer: Yes, it will read and write via Jtag mode. Continental CM2350 – Cummins pinout to foxflash Kit to use: – Multifunction cable – Rainbow flat cable Connect multifunction cable as follows: Solder the rainbow flat cable and make a link: To… Read More »
Finally everything worked fine. Fetrotech tool is fast with bmw mevd17.2.4. Follow pinout in the tool Read ok Checksum by tool Write OK. www.iecutool.com
BMW MSD87 read and write data with foxflash successfully. Foxflash pinout to BMW MSD87 SIEMENS MSD87 [ TC1796 INT-EXT.F.] – BMW Step 1: Password Search To find the password, connect via OBD to the car. Use the driver: → TOOLS BOOT MODE → INFINEON TRICORE Tool Password → OBD PASSWORD MSD80/81/85/87 BMW → Click… Read More »
