PCMTuner dongle (pcmflash 1.2.0) will read Gen2 Mazda3 (2010+) ECU via OBD module 9. If already remove ECU from car, it can be read via OBD on bench mode using Godiag adapters. Tools used: Scanmatik pro2 PCMTuner dongle Godiag GT100+ breakout box Godiag ECU Boot GPT adapter (the adapter can be used with pcmflash… Read More »
Question: I have only pcmtuner usb dongle and geniune scanmatik, What is the procedure for using pcmflash on my new computer. Which version installed? I have an activation problem. Answer: You can install dongle drivers on many many computers and use pcm-flash 1.20 on them too. Contact www.iecutool.com to send you working software. You… Read More »
Problem 1: Pcmtuner device not found What’s problem I connected 12v and USB is connect. Solution: Restart PC, restart PCM unit, try reinstall drivers, and test again. Problem 2: If get both “user not activated” and “dongle USB device not found” errors. 1.Must send email and device serial number to tuner-box.com to activate… Read More »
Question: Anyone tried using pcmtuner dongle 1.2.6 with pcmflash powerbox and openport 2.0? Does it work? If yes is it fully functional as pcmtuner or some modules doesn’t work? Like instead of buying full kit pcmtuner i would buy just dongle if it works the same, the reason that i will lose the DSG cables… Read More »
Problem: Try to read Toyota revo year 2021 with Tactrix openport 2.0 and pcmtuner dongle. what’s the problem (I can read but not write). pcmflash says there was a problem preparing the selected file. Cause: newer UDS protocol needed for Toyota 2020>>> cannot do on this version Revo2020 use PCM Flash 1.2.1 or higher version… Read More »
Received my pcmtuner usb dongle and tested with Nissan /Infinity K-Line module 15, with ECU Nissan Hitachi A56 – R60 with original SM2 Pro, identification and reading was faster and successful, I welcome this new kid in my block!!
As titled, here is the instruction to remove a chip of the old pcmtuner dongle to avoid dongle hot problem. The new dongle has removed the chip before delivery. The guide here is for dongles manufactured after June 8th, 2022. to remove the chip, print some weld oil on chip make hot air degrees to… Read More »
Good news! PCMTuner team has updated the pcmtuner smart dongle. They have removed the encrypted chip, no overheat issue anymore. The old dongle can get hot, but it is normal because it is LED. Check the new usb dongle pcmtuner dongle that comes with pcmtuner device (Item Number SE157) pcmtuner usb dongle (SE157-S) … Read More »
Question: My pcmtuner USB dongle not accessible. The dongle stops communication and threw an error USB not accessible. Any Solution? Solution: You update pcmflash. NEVER update pcmflash. Remove complete from pc and reinstall software. The pcmtuner hardware won’t be locked. How to fix it if update pcmflash by mistake? Delete current pcm flash ONLY. Install… Read More »
We notice that you have met a few problems while using our PCMtuner, Here we would like to share our solution with you. 1. Why does my dongle get heat? There is a chip inside of the dongle, it is set for a safe factory, and it is the reason for the dongle getting hot. If… Read More »
