Problem: Foxflash reads Nissan EDC17C42 ECU ok, but failed to write. Error Non-Eraseable Sector in bench mode. Any solution? Solution: Bad file. Somebody change values in OTP areas. Change your file supplier. Read also: http://www.pcmtuner.org/foxflash-benz-edc17cp46-write-error-non-eraseable-sector/
Will Foxflash read and write BMW Simens or Continental MSV80 MSD80 MSD85 etc DMEs? Yes, via OBD or boot mode. If failed to read it via OBD (error data2), raise the voltage and try again, if still failed, try boot mode. Foxflash tool BMW MSV80 Boot pin SIEMENS MSV80 Vers.1 [ TC1796 INT.F.] – BMW… Read More »
Foxflash tool read and write Peugeot Boxer 2.0 Hdi 2017 DCM6.2c ECU successfully via OBD. Read ok Write ok Stage 1 , Adblue delete by Foxflash Select driver Car OBD Peugeot Boxer 2.0 BlueHDI 16V Delphi DCM 6.2C *CAN Get ID If it fails, give error wake, select the driver and try again. It… Read More »
Foxflash can read Renault SID310 but failed to write via OBD? How to fix it? Solution: Don’t save file to disk C or desktop. (Better on disk D or F.) Try again if still fails, there is no VR file for this car on server. Read and write it in boot mode. http://www.pcmtuner.org/read-renault-sid310-with-foxflash-in-boot-mode/
FoxFlash ECU TCU tool is now able to perform the OBD unlock patch Chrysler GPEC2 & GPEC2A. OBD unlock patch November 02, 2023 foxFlash is now able to perform the following operations: OBD unlock patch On the following ECU references: Continental GPEC2 & GPEC2A Jeep 2.4 Tigershark 184 hp Jeep 3.2 Pentastar V6 275 hp… Read More »
It is a Mercedes Sprinter edc17cp46. Foxflash tool read ecu ok, but cannot write. Error “non-eraseable sector in bench mode” possible from checksum correction? Solution: Bad file. Somebody change values in OTP areas. Change your file supplier.
Problem: Foxflash read PSA MD1CS003 ECU fine but failed to write. Any solution? Solution: Your battery is low. 12.1v on bench seems less to this ECU. Better with 13.5V and 2-3A. If still fails, fix checksum manually and write back. If ECU is after 2020, it is not possible to remap that ECU (with OTP… Read More »
Silver fetrotech tool read and write PSA EDC16C34 ecu successfully. Edc16 c34 psa Read/write ok Checksum by Lsuite (fetrotech will do checksum correction, but i do manually) First time won’t wrie, voltage at 12,5 Adjusted to 13,5v went fast.
Problem: Foxflash read Renault MD1CS006 ecu ok, but failed to write ecu. Error “Modification is not allowed in virtual OTP Zone”. Any solution? Solution: You have modified your file in otp area. The edited file is bad. Change your file supplier, send original file, modify file and rewrite. www.iecutool.com
Problem: I cannot read Audi A1 1.4tfs MED 17.5.5 with foxflash tool on bench and obd?? I can only identify and write. Failed to read also a seat ibiza 1.4tfsi med 17.5.5 impossible obd boots bench. Possible solutions: If read it via OBD, try to go up to 14 volts normally it should pass. If… Read More »
